2024 Author: Beatrice Philips | [email protected]. Last modified: 2024-01-18 12:09
None of the equipment is insured against breakdowns. And even a relatively new TV (but, alas, already out of the warranty period) can start to behave strangely. For example, turn on and off on your own. There may be several reasons for this, respectively, and there is more than one way to eliminate them.
Common Causes
If the TV turns on and / or off by itself, this may be a typical software-related error of modern technology. Such a malfunction can only be excluded with CRT TVs . (although, albeit rarely, this happens to them). Before running to the service center, you should try to figure out the problem yourself.
Attention! Any diagnosis requires caution and basic safety precautions. Disconnect the equipment from the mains.
There are two most common reasons the TV turns off on its own
- Incorrect device setting function . There is no reception signal, so the TV turns off on its own. The owner often falls asleep while watching movies (and this is not uncommon), and the TV “thinks” that it is time to switch off. With such an incorrect setting, by the way, a visible malfunction may occur.
- The device has a program that sets the on / off mode . But the owner of the TV either does not know about it, or has forgotten about such a setting.
Of course, these reasons alone cannot explain the malfunction. And if the new technique behaves this way, the issue will be resolved by the warranty service, but if you cannot count on free service, you need to urgently understand the problem.
Consider what should be checked
You just need to look at the contact density of the socket and plug . If the plug is loose, it will periodically come loose from the contact, and the TV turns off. This is especially likely if it turns off as soon as the movement of households or animals around the apartment is noticeable. They create vibrations that worsen the already wobbly position of the plug in the outlet. In such a situation, the TV turns off less often at night. But at the same time, he himself does not turn on.
Dust accumulation . If the owners of computers and laptops carefully clean their gadgets, blow them through, then TVs are often forgotten. But dust can also accumulate inside it. In most cases, the devices are of course protected by a housing with lattice openings. They are blocked from dust. But the risk of dusting still remains, albeit minimal.
Power supply problems … First you need to check the standby indicator. If such a detail is blinking, then it is probably the power board that is responsible. Here, either carry the TV to the service, or change the defective parts yourself.
Voltage surges … If the TV is used for a long time, cracks appear on its board after a while. And humidity, instability of power indicators, high temperatures lead to breakage of connections and swollen capacitors.
Overheat … It happens due to both unstable voltage and continuous use. LEDs, insulating winding may be damaged. In this case, the device turns off with a characteristic click.
If all this is excluded, most likely, it is the program that is "to blame " … For example, an expensive, newly purchased LG or Samsung TV began to turn on itself, and at different times. And it could be about smart settings. There is an option that the user himself did not disable the software update module, which made the device configured on its own, automatically. Or, for example, a program is installed on the TV that gives the TV a command, so it turns on itself.
You need to look for the reason yourself, and if nothing is found, then you need to call the master.
He must know how long such a malfunction has manifested itself, how long after turning off the equipment turns on again, what diagnostic measures the user himself has already taken.
Debugg
You need to watch the TV like any other technique .… And it should be done regularly, for example, do not allow dust to accumulate on any of its parts.
Dust has accumulated
For cleaning TV do not use alcohol and alcohol-containing products, acids , since under their influence the matrix elements will soon fail. Detergents for dishes and glasses are also not suitable for cleaning the TV. But sometimes you can use tools for monitor screens, consultants in an electrical store will tell you which of these care products are more effective.
Cleaning the TV with newspapers from dust is another "bad habit" of the owners … The paper will scratch the screen easily and may leave newspaper fibers on the screen, which will adversely affect the clarity of the image. Soda will be the same prohibited cleaning agent. Abrasive particles will scratch the screen and cause cracks. And to wash it without the formation of streaks is almost unrealistic.
Dust must be disposed of correctly
- Dry cleaning should be carried out once every 3 days . This will save the TV from both dust accumulation and staining. Microfiber napkins, soft lint-free fabrics (cotton), special dry napkins for cleaning monitors will help in this.
- After all accessible parts of the device have been cleaned, keep the TV off for 15 minutes .
Important! Do not use a spray bottle when cleaning the screen: liquid may end up in its corners and cannot be removed from there. Such cleaning is fraught with serious malfunctions later.
There are problems with the power supply circuit
A power failure may also cause the TV to turn on / off on its own. For example, the wire is broken, the socket contacts are worn out. Because of this, the technique either suddenly turns off or stops turning on altogether.
If, when the TV is on, you shake the wire or the plug, and the picture on the screen disappears, then the cause of the malfunction is in the power circuit . Try plugging the TV into a different outlet (you may need an extension cord for this). So you can find a specific breakdown location, it will have to be replaced.
Voltage drops present
When one of the phases of the mains is overloaded, the following happens: the voltage of one phase sags, the voltage of others rises. Emergency modes are not excluded, when the zero extension of the transformer breaks, or when the phase hits the neutral wire. If the house falls into a lowered phase, then in the worst case, electrical appliances in the apartments may turn off. They will turn on as soon as the potential is leveled.
But increased voltage is more dangerous . The standard network parameters for LED TVs and plasma devices is 180-250 V. If this figure is exceeded, the electronics suffer from overload, and the likelihood of burnout of boards increases. And this can also cause the TV to turn off suddenly.
The situation can be corrected by installing an outlet voltage relay. It can be installed throughout the apartment, which means that all electrical appliances will be protected from power surges. You can also install a voltage stabilizer, but such a device takes up a lot of space and looks bulky in the interior.
Prevention measures
There are simple rules, which are easy to follow, but they will help the TV to serve for a long time and without malfunctions
- Must be turn off the TV at least after 6 hours of continuous operation .
- It is important to monitor the brightness of the image . If the brightness is lowered, the backlight lamp needs to be replaced.
- The screen must be protected from shock and damage . If there are small children in the house, it is better to mount the TV on the wall, and not to put it on a curbstone or other low furniture. And it is also safe for children - alas, TV falls are not rare. Of course, do not forget about cleaning the TV - dust should not accumulate on it.
- Often you don't need to turn the device on and off either .… If you turn on the TV and change your mind to watch it, the shutdown should happen no earlier than 15 seconds later.
- Timely follows update the software .
- Immediately after purchase, you need to check the settings system . It can theoretically get lost, but if this happened with a new TV, it needs to be sent for repair or replacement.
Finally, it is worth remembering that the same young children can play with the remote control, get into the settings and accidentally program the TV to turn on and off at a certain interval. Parents do not even know about this reason for the malfunction, they remove the device from the wall, take it for repair. And the solution to the problem is much simpler.
Recommended:
The Earth Turns Green: In A Greenhouse, A Greenhouse And A Vegetable Garden. What To Do, The Causes Of Green Soil In The Beds. Why Are They Covered With Bloom And Moss, How To Process It?
What to do if the ground in the greenhouse turns green? The reasons for the green soil in the beds, in the greenhouse and in the garden. Why is the ground covered with bloom and moss? How can the soil be cultivated? Prevention measures
The LED Strip Is Blinking: Why Is It Blinking In The On State And After It Is Turned Off? What Should I Do If It Blinks When Turned On? Main Reasons
What causes the LED strip to blink most often? Why does it blink when turned on and after turning off? What to do if such problems occur? How can you independently find the cause of the malfunction? Do you always need to change the power supply unit? Consider general recommendations
The TV Turns On And Turns Off Immediately: The Reasons Due To Which The TV Screen Goes Out After Turning On
TV is an integral part of modern living space. Why does a household appliance turn on and off immediately? A list of possible problems, and their main causes. How to solve the problem on your own and in what cases is it better to contact the service center? Basic preventive measures to help avoid breakdowns and technical problems
Thuja Turned Black: What To Do If Spots Are Below? Causes Of Blackening Of Branches And Leaves. How To Deal With This?
Having discovered that the thuja has turned black, not every gardener knows what to do in this situation. What to do if stains are underneath? What are the main causes of blackening of branches and leaves and how to deal with it?
What If The Bark Of An Apple Tree Peels Off? Why Does The Bark Of An Old And Young Apple Tree Crack And Peel Off? What Can Be Processed? Causes
What if the bark of an apple tree peels off? Why does the bark of an old and young apple tree crack and peel off? How can fruit trees be treated when the bark is cracked?