How To Cut Chipboard With A Jigsaw Without Chips? What Kind Of Saw Do You Need For A Clean Cut? Features Of Work At Home

2024 Author: Beatrice Philips | [email protected]. Last modified: 2023-12-16 05:33

Laminated chipboard is one of the most widespread materials used in the independent manufacture of furniture. You can talk about its advantages and disadvantages for a long time. But it is much more important to learn how to cut chipboard with a jigsaw without chips.

Features and recommendations

Experts and connoisseurs advise doing this kind of work with electric jigsaws just because an ordinary hand hacksaw is too rough. It does not allow you to cut the material straight enough. The correct sequence of steps is as follows:

• preparation of tools (ruler, jigsaw, measuring tape, awl or other sharp device for drawing on chipboard);
• addition of these tools (if necessary) with a square for laying right angles;
• measurement of the desired part (with a reserve of 0.2 cm so that you can fit);

• drawing a line along the ruler;
• in fact, the cut along the laid line;
• completion of the saw cut with sandpaper;
• with a very poor quality of the end - rubbing it with a fine, similar in tonality to chipboard.

What else do you need to know?

When it is planned to saw off everything without chips on one side, it is permissible to use saws with both upper and lower teeth. Most craftsmen prefer small, straight-toothed files. Such devices chip less material, but at the same time they work pretty well. After the saw cut, it is best to process the ends with emery stretched over even bars. If there is no ready-made crayon of a suitable color, you can mix different crayons, like paints in an artist's palette, and get a new color.

To cut without errors and moreover quickly, you must always take into account the brand markings . There is no universally binding standard for designations yet, but almost all companies strictly follow the classification developed by Bosch specialists. Or at least indicate it along with their own abbreviations and terms. For cutting wood and wood-based products, CV files (sometimes referred to as HCS) are well suited.

For processing laminated panels, Hardwood saws are intended (they are also useful, we note, when processing hardwood).

Some inscriptions indicate in which mode the tool works optimally:

• basic - a simple blade that allows you to make a clean cut of high quality;
• speed - a device whose teeth are set apart (this allows you to cut faster);
• clean - a canvas that has not been diluted (usually gives the cleanest cut).

If the workpiece is relatively thick, preferably a saw blade with large incisors that have not been set, then there will be minimal deviation from the vertical. The longitudinal (in relation to the fibers) cut is most often made with helical saws. For a transverse, a straight blade is better. When you plan to make a blank for furniture, it is advisable to choose a less productive, but more accurate tool. Since most of the saws on the market today cut the material as it is pulled in, the workpiece will need to be machined from the inside out.

Completing of the work

When the file is selected, you still need to properly saw the laminated board at home. Experts recommend sawing along a guide (a rail clamped in clamps is also suitable). If you use a new, unworn blade, you can cut the chipboard as cleanly as you would with a circular saw. It is advisable to turn on the jigsaw at the lowest speed possible. This will significantly increase the resource of each file used.

The canvases themselves are placed at right angles to the sole of the jigsaw . The easiest way to adjust the angle is with a square or protractor. Important: the straight line passing through the cutting edge of the tool must be parallel to the rigidly fixed part of the jigsaw. It is recommended to use special inserts to reduce the chance of splitting. But to make them work more efficiently, they usually cut the laminate from the side where the blade will come out.