2024 Author: Beatrice Philips | [email protected]. Last modified: 2024-01-07 13:49
Dauer sand concrete of the M-300 brand is an environmentally friendly building mixture, in a frozen state, harmless to human health. Working with the material has its own specifics, so you should first study the main characteristics and rules for using Dauer sand concrete. It is used not only for the construction of buildings and outdoor applications, but also for interior decoration of various surfaces.
Characteristics and purpose
The material is made in accordance with the norms and requirements of the state standard, regulated by the document GOST 7473-2010. Sand concrete is a homogeneous powdery substance of gray coarse-grained components.
The main constituent elements of the material are inorganic binder Portland cement and fractionated river sand . Various additives, additives and mineral fillers can also be used to increase a number of working properties. After mixing with water and preparing the working solution, it becomes mobile, transforms into a plastic, non-exfoliating composition.
Differs in durability, high characteristics of strength and reliability, adheres well to various concrete surfaces.
The main technical characteristics of the material are shown in the table
Approximate consumption of the finished solution when creating a 10 mm layer |
20 kg per m2 |
Maximum filler size | 5 mm |
Approximate amount of water for mixing the working solution per 1 kg of dry mix | 0.13-0.15 liters |
Mobility indicator | brand Pk2 |
Minimum strength indicator | M-300 |
Frost resistance | 150 cycles |
Range of permissible temperatures for the solidified solution | from -50 to +70 degrees Celsius |
Regulatory normative document | GOST 29013-98 |
The ready-to-use solution must be used no more than 2 hours after mixing it; in winter, at low temperatures, the viability of the composition sharply decreases - up to 60 minutes . And also when working with a ready-made solution, certain conditions must be observed: when using the composition, the recommended temperature of the ambient air and the surface to be treated should be in the range from +5 to +30 degrees. If work is carried out in winter at temperatures below +5 degrees, it will be necessary to add a special anti-freeze additive to the composition, which allows the solution to be used in conditions from -10 to -15 degrees Celsius.
For the convenience of consumers, sand concrete is sold in various packaging - 25 kg, 40 kg and 50 kg.
Dauer M-300 sand concrete is used for various general construction works:
- pouring screeds;
- sealing seams, cracks or gouges;
- creation of concrete structures;
- erection of buildings from bricks, natural stone and blocks;
- plastering of walls;
- production of stairs, paving slabs and other concrete products;
- creating and pouring foundations;
- preparation of the base for the underfloor heating system;
- restoration work;
- elimination of defects and leveling of various surfaces.
Consumption
The consumption of sand concrete directly depends on the type of work performed and conditions. When pouring a floor screed with a thickness of 10 millimeters per 1 square meter of area, at least 20 kilograms of material will be required . If the foundation is being poured or other similar reinforced concrete work, then about 1.5 kilograms of dry mixture is consumed per 1 cubic meter of the finished solution. For plastering walls or sealing cracks, as well as for restoration work, 18 kilograms of material will be enough per square meter (with a 10 mm layer).
Instructions for use
Before applying the mortar from Dauer sand concrete, it is necessary to carefully prepare and clean the surface to be treated - remove all dirt, paint residues, oils, remove the exfoliation of old material. It is also recommended to remove dust and slightly moisten the surface, and pre-treat bases made of highly absorbent materials (for example, gypsum or foam concrete) with a primer.
To prepare the solution, you will need to pour the required amount of the mixture into a metal container or concrete mixer and add a certain amount of water based on the calculations presented in the table. Stir well until a homogeneous elastic mass is formed. The volumes of water can be varied to create a consistency suitable for the job. Let the mixed composition brew a little (up to 5 minutes), and mix again.
If a concrete solution is being prepared, then it is necessary to add fine crushed stone, the proportions will depend on the type of construction work - approximate calculations are usually indicated by the manufacturer on the package. To improve the basic properties and technical characteristics of the material, various additives and fillers are added to the composition . They increase the frost resistance of the mortar, strength, reliability and durability of the manufactured structures, improve the heat and sound insulation of structures. The amount and type of additives will also depend on the type and conditions of construction work.
After preparation, the working solution must be applied to the prepared surface and evenly distributed using profile construction tools . During work, especially with frequent breaks, it is recommended to always monitor the condition of the mixture - to prevent drying, periodically add a small amount of water to the composition.
Protect the solution from strong wind, rain, direct sunlight.
Precautionary measures
Dauer M-300 is safe for humans in a ready-made solidified form, but a dry mixture and working solution can be harmful to health. Therefore, the material should be protected from children, while working with it, use gloves and safety glasses.
In case of accidental contact with skin, rinse thoroughly with water, in case of contact with eyes, rinse immediately with plenty of water and go to a hospital.
Recommended:
Sand Concrete For Screed: Consumption Per 1 M2 Of Floor. The Best Brand Of Sand Concrete For Screed Construction. Semi-dry Sand Concrete Screed From Expanded Clay And Sand Concrete
Sand concrete for screed, features. Consumption per 1 m2 of floor. The best brand of sand concrete for screed construction. Semi-dry sand concrete screed from expanded clay and sand concrete
Sand Concrete On The Foundation: Features Of The Foundation Sand Concrete Blocks, Grades Of Sand Concrete For The Foundation. Can I Fill In? Solution Proportions
What sand concrete for the foundation to choose? The main brands of sand concrete for the foundation and features of the foundation sand concrete blocks. How to fill the foundation? How to prepare the solution correctly?
Concrete Mixers 120 Liters: Dimensions And Productivity Of Concrete Mixers 120 Liters. How To Pour Concrete And Use A Concrete Mixer? Power
Features of concrete mixers with a volume of 120 liters. What are the advantages and disadvantages of such units? What is the capacity of 120 l concrete mixers and their dimensions? Rules for the operation of concrete mixers. Order of filling ingredients
Arbolite Or Expanded Clay Concrete: Which Is Better? Thermal Conductivity Of Wood Concrete In Comparison With Foam Concrete, Sawdust Concrete, Aerated Concrete, Polystyrene Concrete And Straw Blocks
Before building any structure, it is important to decide which of the building materials is suitable for this. For example, wood concrete or expanded clay concrete. These are two lightweight concrete types with their own advantages and disadvantages. But which one is better? And how much the thermal conductivity coefficient of wood concrete differs in comparison with foam concrete, gas silicate and sawdust concrete
Sand Concrete Of The M500 Brand: The Composition Of The Sand Concrete Mixture, Application And Proportions. What Is The Flow Rate For 1m2?
What is M500 sand concrete and what are its characteristics? The composition of the sand concrete mixture, application and proportions. Where is it used? What is the consumption of such a mixture per 1m2?