LED Floodlights 100 W: Street Models 100 W (watt) And Home Floodlights For Lighting. How Do They Shine? Rechargeable Portable Models And Others

2024 Author: Beatrice Philips | [email protected]. Last modified: 2024-01-18 12:09

LED floodlight is the latest generation of high power luminaires, replacing tungsten and fluorescent lamps. With the calculated power supply characteristics, it generates almost no heat, converting up to 90% of electricity into light.

Pros and cons

LED floodlights have a lot of advantages

1. Profitability . Highest efficiency. They hardly get hot, if you do not exceed the average operating current and voltage on the LEDs. Unfortunately, manufacturers are doing just that for the sake of constant super-profit, releasing billions of copies a year. Compared to an incandescent lamp, the electricity savings on the meter reach 15 times the value with the same light output in lumens.
2. Durability . As the advertisement promises, LEDs last up to 100,000 hours, if, again, you do not replace the operating voltage of the LED on with its peak value.
3. Moisture protection . LEDs are not afraid of precipitation (if it's not frosty outside). This fully applies to simple super-bright ones, whose operating current reaches 20 milliamperes. Other varieties, including unpackaged LEDs, still need silicone protection.
4. Cooling sealed enclosure . The rear wall of the floodlight is a ribbed radiator. The floodlight is not afraid of pouring rain - it is maximally protected by dense spacers made of soft plastic and a rubber layer.
5. It can be connected to a 220 volt network . If the floodlight is not designed to be powered from 12/24/36 V (without driver), then it can be immediately connected to the public mains.

6. Suitable for lighting areas over a hundred square meters . At the same time, the 100-watt model will illuminate a decent-sized area. It will also replace an outdoor LED floodlight mounted directly on the suspension of a pole lamp.

Disadvantage: cannot be used in an apartment or a country house - even a power of 10 W can create a dazzling effect.

For home (residential) premises, there are chandeliers, wall, table and recessed lamps with frosted bulbs that diffuse the emitted light . The searchlight does not have such a diffuser - it has only transparent tempered glass.

Main characteristics

The luminous flux of 100 W floodlights reaches several thousand lumens. Luminosity in lumens per watt of consumed power depends on the LEDs . Small LEDs without a housing, used in lamps for a room, have a consumption current of about 60 mA, that is, they give off an average of 3 times more light than standard housing ones.

The opening angle of the light flux is about 90 degrees . Open-frame LEDs, the light from which is not corrected by a separate (external) lens, do not have a sharp directivity pattern. If you focus the light with a separate lens, then you can get only a pattern of bright luminous points separated by less light gaps. Additional lenses are rarely installed in spotlights - the goal is to illuminate a wide area under them, and not concentrate the beam over several kilometers.

In spotlights, mainly SMD LEDs are used, less often COB assemblies . A driver for network floodlights, whose supply voltage is common to many household electrical appliances, is a board that not only rectifies alternating voltage, but lowers it to a level at which it is relatively safe for humans. The driver controls the operating current, the latter is rigidly set, and if there are more LEDs than intended in a particular model, it simply will not give a bright light on the LED matrix.

Prophylaxis of the searchlight is excluded - it is a non-separable device.

According to advertising statements, it can work without problems for 5 years around the clock . In fact, the service life decreases from 50-100 thousand hours to only 1-3 hours due to the deliberate overestimation of the operating current by manufacturers.

The weather temperature ranges from -50 to +50 degrees. The spotlight will start in almost any weather.

Moisture protection of the floodlight is no worse than IP66 . This is enough to protect the product from showers and dirt.

Tempered glass makes these floodlights, in fact, explosion-proof products. This glass is not immediately broken, even with a hammer.

Street floodlights are equipped with a motion sensor, which saves resources and energy . The light turns on on such a spotlight only when a person or a car appears nearby. For example, the spotlight will not react to dogs and cats. The light matrix turns on only for a minute - after stopping the movement, which it is able to catch near the searchlight with the help of this sensor, it will turn off automatically.

What are they?

For street lighting, a floodlight with a capacity of several tens of watts is suitable. It is powered by 220 V. Its analogue - a rechargeable battery - is a portable, portable solution, the scope of application is work at night in hard-to-reach places where there is no centralized lighting . Street floodlights emit cold light - from 6500 Kelvin. For residential and work premises, a warm glow is more suitable - no more than 5000 K. The fact is that the cold one contains rays that are shifted far to the blue edge of the visible spectrum and reach almost to low-frequency (long-wave) ultraviolet radiation, which will not have the best effect on vision.

Therefore, cold light is used in places where people are not present for a long time - for example, emergency lighting in the yard, mainly on the street.

Popular brands

Rely on high-quality models - it is desirable that they are entirely produced in Russia or in any of the countries of Europe or America. Most of the products are Chinese, you should be careful when choosing them. Good products come from Korea and Japan. As an example, there are several popular 220V models.

Falcon Eye FE-CF30LED-pro;

Feron 32088 LL-912

"Nanosvet L412 NFL-SMD"

Gauss 613100350 LED IP65 6500K

Navigator NFL-M-50-4K-IP65-LED

Wolta WFL-10W / 06W

Solar panels are a new fashion and a tribute to technical and technological progress.

They are installed on road signs in places where it is extremely difficult to stretch the cable to the nearest pole

Globo Solar AL 3715S;

Novotech 357345

Street models with motion detection for people and cars nearby:

Novotech Armin 357530;

"SDO-5DVR-20"

Globo Projecteur 34219S

? This is not a complete list - there are actually hundreds of models on sale in Russia. The current rating is based on reviews and votes and is constantly changing. Focus on positive reviews from verified, real buyers.

Selection Tips

Check the spotlight carefully for external defects

1. Unevenly laid gaskets between the glass and the body, from the side of the input of the supply cable.
2. Close fit of components to each other - for example, the removable front frame and the main body.
3. The possible presence of chips, indicating a fall of the product from a height, its use for other purposes.
4. The LED matrix should not contain crooked, asymmetrically mounted LEDs. The defective product must be replaced with a normal one.

Ask the seller to plug in the spotlight (or connect it to the battery) . This will reveal the unstable glow or complete inoperability of the "broken" LEDs. However, it often happens that due to the series-connected LEDs - and in the presence of one inoperative - the entire assembly refuses to light up. Burned-out LEDs are visible in dots - the crystal, or rather, its point, to which the thread is brought, turns black at the moment of burnout.

Make sure the glass is clear and not scratched . Tempered glass is difficult to scratch. In addition, if at least one crack appears on it, it cracks over the entire area and crumbles into the same crumb.

Despite the fact that the searchlight can work properly, a strong blow will not slow down its effect on its stable operation.

Do not buy a spotlight that is not claimed to cover a specific area with sufficient light at night. However, cheap Chinese fakes are unlikely to give out 100 watts - at best, there will be 70 watts.

Do not forget that a 100 W diode floodlight consumes, and does not give out, the declared power . Considering its considerable heating due to design discrepancies, it is able to dissipate up to 40% of the consumed power for heat.